Add to ORKGEvaluates available experimental techniques for the determination of Young's modules. Tensile, bend, resonance and speed of sound tests were performed.Thesis (M.D.S.) -- University of Adelaide, Dept. of Dentistry, 199
Luminosity measurements at the high luminosity points of the LHC are very challenging due to the ext...
An Autosort Mark II wafer flatness tester was installed and initial runs and performance testing acc...
An imaging technique using TM polarized illumination at 45 degree incidence to a highly reflective s...
A thin stiffened metal cylinder liable to General Instability was tested under axial compression and...
A preliminary study of a new method for determining respirable mass concentration is described. This...
This paper describes an interactive set of tools used to determine the safety of tunnels and to prov...
Efficient, robust simulation of groundwater flow in the unsaturated zone remains difficult for probl...
We present the results of a study for the design of a fastextraction kicker to be installed in the A...
Modifications were made to a bench-top dustiness tester to allow for the simultaneous collection of ...
The validation for a low-cost, real-time probe was made in order to detect particle breakthrough of ...
A technique for electrically measuring alignment errors is described and employed to characterize a ...
Lattice-Boltzmann modeling was used to simulate single-phase, non-Darcy flow through flow domains co...
The Tegal 700 plasma etcher was used to etch trenches into four micron deep p-type diffused resistor...
A study has been performed to investigate oxynitrides as thin gate dielectrics. The method of nitrid...
We present the initial results of an experimental study of abeam timing monitor based on an optoelec...
Luminosity measurements at the high luminosity points of the LHC are very challenging due to the ext...
An Autosort Mark II wafer flatness tester was installed and initial runs and performance testing acc...
An imaging technique using TM polarized illumination at 45 degree incidence to a highly reflective s...
A thin stiffened metal cylinder liable to General Instability was tested under axial compression and...
A preliminary study of a new method for determining respirable mass concentration is described. This...
This paper describes an interactive set of tools used to determine the safety of tunnels and to prov...
Efficient, robust simulation of groundwater flow in the unsaturated zone remains difficult for probl...
We present the results of a study for the design of a fastextraction kicker to be installed in the A...
Modifications were made to a bench-top dustiness tester to allow for the simultaneous collection of ...
The validation for a low-cost, real-time probe was made in order to detect particle breakthrough of ...
A technique for electrically measuring alignment errors is described and employed to characterize a ...
Lattice-Boltzmann modeling was used to simulate single-phase, non-Darcy flow through flow domains co...
The Tegal 700 plasma etcher was used to etch trenches into four micron deep p-type diffused resistor...
A study has been performed to investigate oxynitrides as thin gate dielectrics. The method of nitrid...
We present the initial results of an experimental study of abeam timing monitor based on an optoelec...
Luminosity measurements at the high luminosity points of the LHC are very challenging due to the ext...
An Autosort Mark II wafer flatness tester was installed and initial runs and performance testing acc...
An imaging technique using TM polarized illumination at 45 degree incidence to a highly reflective s...