Ground Movements in the Zagros Fold-Thrust Belt of SW Iran Measured by GPS and InSAR Compared to Physical Models

This thesis uses geodetic satellite data to measure present-day crustal deformation in the Zagros fold-thrust belt (SW Iran). Geodetic-type measurements are also used in down-scaled models that simulate the surface deformations seen in convergent settings like the Zagros fold-thrust belt. Global Positioning System (GPS) measurements of three surveys between 1998 and 2001 indicate 9 ± 3 mm/yr and 5 ± 3 mm/yr shortening across the SE and NW Zagros respectively. GPS results show that in addition to the different rates and directions of shortening on either side of the NS trending Kazerun fault, local along-belt extension occurs to the east. Differential SAR interferograms of ERS1 & 2 images between 1992 and 1999 detect 8 ± 4 mm/yr uplift rate across a newly recognized fault in SW Qeshm Island. This can be attributed to a steep imbricate thrust that may still represent the local Zagros deformation front. The salt diapirs in the Zagros rise from a source layer that acts as a low-frictional decollement that decouples the deformation of the cover sediments from their basement in the eastern Zagros whereas the cover to the west deforms above a high-friction decollement. Physical models were prepared to simulate cover deformation in the Zagros by shortening a sand pack above adjacent high- and low-frictional decollements (represented by a ductile layer). The strain distributions differed above the two types of decollements; it was more heterogeneous above the salt where local extension in the shortening direction was dominant. A separate work also investigated systematically the role of basal friction on cover deformation in convergent settings. Accurate height measurements of the model surface by laser-scanner indicated a deformation front more distal than usual, particularly in the low-basal frictional models. The volume reduction in our shortened sand models correlated directly with their basal friction