Fusion Plasma Observations at JET with the TOFOR Neutron Spectrometer : Instrumental Challenges and Physics Results

The neutron spectrometer TOFOR was installed at JET in 2005 for high-rate observation of neutrons from reactions between two deuterium (D) ions. Neutron spectrometry as a fusion plasma diagnostic technique is invoked to obtain information about the velocity states of fusion fuel ions. Based on neutron spectrometry data, conclusions can be drawn on the efficiency of plasma heating schemes as well as optimization of fuel ion confinement. The quality of TOFOR analysis is found to depend on how well the instrument response function is known; discriminator threshold levels, detector time alignment and electronics broadening are identified as crucial issues. About 19 percent of the neutrons observed with TOFOR have scattered off the JET vessel wall or other structures in the line-of-sight before reaching the instrument, as established through simulations and measurements. A method has been developed to take these neutrons into account in the analysis. TOFOR measurements of fast deuterium distributions are seen to agree with distributions deduced from NPA data, obtained based on an entirely different principle. This serves as validation of the modeling and analysis. Extraordinary statistics in the TOFOR measurements from JET pulses heated with 3rd harmonic RF heating on D beams allow for study of instabilities using neutron emission spectrometry. At ITER, similar studies should be possible on a more regular basis due to higher neutron rates. Observations of neutrons from Be+3He reactions in the TOFOR spectrum from D plasmas heated with fundamental RF tuned to minority 3He raise the question of beryllium neutrons at JET after installation of the ITER-like wall, and at ITER, with beryllium as the plasma facing component. This is especially important for the first few years of ITER operation, where the machine will not yet have been certified as a nuclear facility and should be run in zero-activation mode