Fiber riktningen på sågade ytor : Kan fiber riktningen på sågade ytor bestämmas med hjälp av högupplöst scanning

In 2013 the European journal of wood and wood products published an article regarding a new method to predict strength in structural timber (Olsson et al 2013). By determining the fibres orientation on all four surfaces of each board in sample of timber using a high resolution scanner the authors were able to achieve a coefficient of determination, R2, as high as 0.71 between bending strength and a new indicating property (IP). For the same sample of timber Olsson et al (2013) determined the R2 by axial dynamic excitation as 0.59. However, all boards used in their investigation were planed before scanning. This study examines if a high resolution scanner could be used to determine the fibre orientation on the surfaces of sawn timber boards of Norway spruce. Both band sawn surfaces and circular sawn surfaces were examined. The procedure in this investigation is described as follows. Firstly, both the band sawn and the circular sawn boards were scanned by a WoodEye® scanner and together with dimensions, weight and the first longitudinal resonance frequency, a modulus of elasticity (MOE) profile was calculated for each board. The MOE profiles were calculated according to Olsson et al (2013) i.e. by a transformation matrix based upon the fibres orientation and a compliance matrix based on material parameters for Norway spruce. Secondly, the corresponding MOE profiles were then determined after the boards had been planed. As a result two MOE profiles were determined for each board. An indicating property (IP) was defined as the lowest value along each MOE profile. To compare the results a regression analysis was performed in which the IPs defined before planing worked as predictor variable and IPs defined after planing worked as response variable. The band sawn band boards yielded an R2 = 0.94 and the circular sawn boards an R2 = 0.93. Further the standard error of estimate was SEE = 829.1 MPa and SEE = 640.9 MPa respectively. As a last step in this investigation the SEE values achieved in this study where implemented on to the sample Olsson et al (2013) used in their investigation