This paper describes an interactive set of tools used to determine the safety of tunnels and to provide data for the decision making of its mainteinance. Although, no doubt, there are still several drawbacks in the difficult procedures in use it is clear that the way is promising and future improvements both in experimental and analytical methods will increase our understanding of this matter
Occupational exposure to endotoxin has been evaluated in Dutch Animal Feed Mills in 1988 and it has ...
KTI-820, a positive photoresist was hardened utilizing two different methods. The PRIST technique in...
The effect of surface cleaning and passivation techniques on the reverse bias saturation current Jo ...
This paper describes an interactive set of tools used to determine the safety of tunnels and to prov...
An imaging technique using TM polarized illumination at 45 degree incidence to a highly reflective s...
Resolution capability of a GCA Mann 4800 DSW Stepper was improved using a bilayer photoresist scheme...
A thin stiffened metal cylinder liable to General Instability was tested under axial compression and...
A common way of designing microelectronic circuits is by the use of standard cells. In advance syste...
The Orange Water and Sewer Authority operates a multiple reservoir system consisting of two primary ...
Modifications were made to a bench-top dustiness tester to allow for the simultaneous collection of ...
A statistical model was used to investigate the relation between compliance with an occupational exp...
This project dealt with the design and installation of a TCA bubbler system. Considerations for safe...
The Tegal 700 plasma etcher was used to etch trenches into four micron deep p-type diffused resistor...
Luminosity measurements at the high luminosity points of the LHC are very challenging due to the ext...
An empirical-conceptual modeling approach was developed by Carlton for estimating worker exposure to...
Occupational exposure to endotoxin has been evaluated in Dutch Animal Feed Mills in 1988 and it has ...
KTI-820, a positive photoresist was hardened utilizing two different methods. The PRIST technique in...
The effect of surface cleaning and passivation techniques on the reverse bias saturation current Jo ...
This paper describes an interactive set of tools used to determine the safety of tunnels and to prov...
An imaging technique using TM polarized illumination at 45 degree incidence to a highly reflective s...
Resolution capability of a GCA Mann 4800 DSW Stepper was improved using a bilayer photoresist scheme...
A thin stiffened metal cylinder liable to General Instability was tested under axial compression and...
A common way of designing microelectronic circuits is by the use of standard cells. In advance syste...
The Orange Water and Sewer Authority operates a multiple reservoir system consisting of two primary ...
Modifications were made to a bench-top dustiness tester to allow for the simultaneous collection of ...
A statistical model was used to investigate the relation between compliance with an occupational exp...
This project dealt with the design and installation of a TCA bubbler system. Considerations for safe...
The Tegal 700 plasma etcher was used to etch trenches into four micron deep p-type diffused resistor...
Luminosity measurements at the high luminosity points of the LHC are very challenging due to the ext...
An empirical-conceptual modeling approach was developed by Carlton for estimating worker exposure to...
Occupational exposure to endotoxin has been evaluated in Dutch Animal Feed Mills in 1988 and it has ...
KTI-820, a positive photoresist was hardened utilizing two different methods. The PRIST technique in...
The effect of surface cleaning and passivation techniques on the reverse bias saturation current Jo ...