Estimating the parameters of polynomial phase signals

Nonstationary signals are common in many environments such as radar, sonar, bioengineering and power systems. The nonstationary nature of the signals found in these environments means that classicalspectralanalysis techniques are notappropriate for estimating the parameters of these signals. Therefore it is important to develop techniques that can accommodate nonstationary signals. This thesis seeks to achieve this by firstly, modelling each component of the signal as having a polynomial phase and by secondly, developing techniques for estimating the parameters of these components. \ud \ud Several approaches can be used for estimating the parameters of polynomial phase signals, eachwithvarying degrees ofsuccess.Criteria to consider in potential estimation algorithms are \ud \ud (i) the signal-to-noise (SNR) ratio threshold of the algorithm, (ii) the amount of computation required for running the algorithm, and (iii) the closeness of the resulting estimates' mean-square errors to the minimum theoretical bound. These criteria will be used to compare the new techniques developed in this thesis with existing techniques. \ud \ud The literature on polynomial phase signal estimation highlights the recurring trade-off between the accuracy of the estimates and the amount of computation required. For example, the Maximum Likelihood (ML) method provides near-optimal estimates above threshold, but also incurs a heavy computational cost for higher order phase signals. On the other hand, multi-linear techniques such as the high-order ambiguity function (HAF) method require little computation, but have a significantly higher SNR threshold than the ML method. \ud \ud Of the existing techniques, the cubic phase (CP) function method is a promising technique because it provides an attractive SNR threshold and computational complexity trade-off. For this reason, the analysis techniques developed in this thesis will be derived from the CP function. \ud \ud A limitation of the CP function is its inability to accurately process phase orders greater than three. Therefore, the first novel contribution to this thesis develops a broadened class of discrete-time higher order phase (HP)functions to address this limitation.This broadened class is achieved by providing a multi-linear extension of the CP function. Monte Carlo simulations are performed to demonstrate the statistical advantage of the HP functions compared to the HAFs. A first order statistical analysis of the HP functions is presented. This analysis verifies the simulation results. \ud \ud The next novel contribution is a technique called the lower SNR cubic phase function (LCPF)method. It is an extension of the CP function, with the extension enabling performance at lower signal-to-noise ratios (SNRs). The improvement of the SNR threshold's performance is achieved by coherently integrating the CP function over a compact interval in the two-dimensional CP function space. The computation of the new algorithm is quite moderate, especially when compared to the ML method. Above threshold, the LCPF method's parameter estimates are asymptotically efficient. Monte Carlo simulation results are presented and a threshold analysis of the algorithm closely predicts the thresholds observed in these results. \ud \ud The next original contribution to this research involves extending the LCPF method so that it is able to process multicomponent cubic phase signals and higher order phase signals. The LCPF method is extended to higher orders by applying a windowing technique as opposed to adjusting the order of the kernel as implemented in the HP function method. To demonstrate the extension of the LCPF method for processing higher order phase signals and multicomponent cubic phase signals, some Monte Carlo simulations are presented. \ud \ud Finally, these estimation techniques are applied to real-worldscenarios in the fields of Power Systems Analysis, Neuroethology and Speech Analysis