Impact of a rub and rinse on solution-induced corneal staining

Purpose. To investigate whether the inclusion of a rub and rinse step before contact lens disinfection has an impact on solution-induced corneal staining.Methods. This was a prospective, double-masked, single investigator study. Twenty participants were recruited for two visits, where balafilcon-A lenses were worn bilaterally for 2 h. Each pair of lenses was prepared using two different methodologies. The “control” lens was transferred from the blister pack directly into a storage case containing polyhexamethylene biguanide-based lens care solution. The contralateral “test” lens was rubbed and simultaneously rinsed using the same polyhexamethylene biguanide-based care solution, for either 60 s (visit 1) or 20 s (visit 2). Both lenses were then soaked in the solution overnight. After baseline corneal staining assessments, the lenses were inserted following a randomized contralateral model. After 2 h, lenses were removed, corneal staining was regraded, and comfort scores were obtained.Results. Rubbed and rinsed test lenses induced significantly less corneal staining than control lenses for all participants during visit 1 (mean ± SD: 516 ± 843 vs. 2170 ± 902; p < 0.001) and visit 2 (522 ± 417 vs. 2091 ± 965; p < 0.001). There was no significant difference between the test lenses during visits 1 and 2 (p = 0.72) or controls (p = 0.50). Comfort scores did not differ between eyes (p > 0.05).Conclusions. Corneal staining induced after 2 h of lens wear with the combination of balafilcon-A and polyhexamethylene biguanide-based lens care solution can be significantly reduced by including a rub and rinse step before overnight soaking. Further work is required to establish the longevity of this effect during the monthly wearing cycle.