Particle size and size distribution is an important parameter in solid liquid separation process especially in granular bed filtration and in dynamic microfiltration. This paper discusses their effects on the above processes from extensive experimental data obtained. In granular bed filtration, the experimental results showed that the initial efficiency follows the pattern reported by previous experimental and theoretical studies, i.e., lower efficiency for particles which fall in the range of critical size of 1 m. However, the particle removal during the transient stage increased with an increase in particle size for the range of sizes studied. An attempt was made to quantify these effects in granular bed filtration using semi-empirical ap...
Internal filtration in slurry bubble columns offers a possible solution to the filtration problems r...
Four sizes (0.095, 0.53, 1.0 and 2.01 μm) of polystyrene latex particles were used to prepare mon...
Deterioration in the filter removal efficiency of submicron particles (l/l0) under unfavorable surfa...
The paper examines the importance of size distribution of the influent suspension on the performance...
The paper examines the importance of suspended particle size distribution in deep bed filtration. Ex...
Depth filtration consists of four major phases: clean bed removal, filter ripening, steady state rem...
[[abstract]]The effects of particle size on the cake properties and the performance of cross-flow mi...
A detailed uncertainty analysis associated with carboxyl-modified latex particle capture in glass be...
International audienceThe transport and filtration behaviour of fine particles (silt) in columns pac...
[[abstract]]The effects of membrane pore size and operating conditions on the particle fouling in “d...
textGranular media filtration is used almost universally to remove particles from drinking water, a...
The process of deep-bed filtration has been studied using a Coulter Counter to analyse the size dist...
Although the principal mechanisms of crossflow microfiltration (MF) are well-known, the practical ap...
Nets, screens, and filters are used to sieve out particles larger than the pore sizes. However, duri...
Deterioration in the filter removal efficiency of submicron particles (l/l0) under unfavorable surfa...
Internal filtration in slurry bubble columns offers a possible solution to the filtration problems r...
Four sizes (0.095, 0.53, 1.0 and 2.01 μm) of polystyrene latex particles were used to prepare mon...
Deterioration in the filter removal efficiency of submicron particles (l/l0) under unfavorable surfa...
The paper examines the importance of size distribution of the influent suspension on the performance...
The paper examines the importance of suspended particle size distribution in deep bed filtration. Ex...
Depth filtration consists of four major phases: clean bed removal, filter ripening, steady state rem...
[[abstract]]The effects of particle size on the cake properties and the performance of cross-flow mi...
A detailed uncertainty analysis associated with carboxyl-modified latex particle capture in glass be...
International audienceThe transport and filtration behaviour of fine particles (silt) in columns pac...
[[abstract]]The effects of membrane pore size and operating conditions on the particle fouling in “d...
textGranular media filtration is used almost universally to remove particles from drinking water, a...
The process of deep-bed filtration has been studied using a Coulter Counter to analyse the size dist...
Although the principal mechanisms of crossflow microfiltration (MF) are well-known, the practical ap...
Nets, screens, and filters are used to sieve out particles larger than the pore sizes. However, duri...
Deterioration in the filter removal efficiency of submicron particles (l/l0) under unfavorable surfa...
Internal filtration in slurry bubble columns offers a possible solution to the filtration problems r...
Four sizes (0.095, 0.53, 1.0 and 2.01 μm) of polystyrene latex particles were used to prepare mon...
Deterioration in the filter removal efficiency of submicron particles (l/l0) under unfavorable surfa...