Postoperative evaluation of tibial footprint and tunnels characteristics after anatomic double-bundle anterior cruciate ligament reconstruction with anatomic aimers

Following anatomic double-bundle anterior cruciate ligament (ACL) reconstruction with hamstring tendon autografts, 38 consecutive patients were evaluated with high-speed three-dimensional computed tomography. Scans were performed within 3 days following surgery. The length and width of the reconstructed ACL footprint were measured on axial images. Then, 3D images were converted into 2D with radiologic density for measurement purposes. Tunnel orientation was measured on AP and lateral views. In the sagittal plane, the center of the anteromedial (AMB) and posterolateral bundle (PLB) tibial attachment positions was calculated as the ratio between the geometric insertion sites with respect to the sagittal diameter of the tibia. In addition, the length from the anterior tibial plateau to the retro-eminence ridge was measured; the relationship of this line with the centers of the AM and PL tunnels was then measured. The AP length of the reconstructed footprint was 17.1 mm +/- A 1.9 mm and the width 7.3 mm +/- A 1.2 m. The distance from retro-eminence ridge to center of AM tunnel was 18.8 mm +/- A 2.8 mm, and the distance from RER to center of PL tunnel was 8.7 mm +/- A 2.6 mm. The distance between tunnels center was 10.1 mm +/- A 1.7 mm. There were no significant differences between the intra- and inter-observer measurements. The bone bridge thickness was 2.1 mm +/- A 0.8 mm. In the sagittal plane, the centers of the tunnel apertures were located at 35.7% +/- A 6.7% and 53.7% +/- A 6.8% of the tibia diameter for the AMB and PLB, respectively. The surface areas of the tunnel apertures were 46.3 mm(2) +/- A 4.4 mm(2) and 36.3 mm(2) +/- A 4.0 mm(2) for the AM and PL tunnels, respectively. The total surface area occupied by both tunnels was 82.6 mm(2) +/- A 7.0 mm(2). In the coronal plane, tunnel orientation showed the AM tunnel was more vertical than the PL tunnel with a 10A degrees divergence (14.8A degrees vs. 24.1A degrees). In the sagittal plane, both tunnels were almost parallel (29.9A degrees and 25.4A degrees for the AM and PL tunnels, respectively). When using anatomic aimers, the morphometric parameters of the reconstructed tibial footprint in terms of length and distances to the surrounding bony landmarks were similar to the native ACL tibial footprint. However, the native footprint width was not restored, and the surface area of the two tunnel apertures was in the lower range of the published values for the native footprint area