GaAs-based Distributed Feedback Laser at 780 nm for 87Rb Cold Atom Quantum Technology

Summary form only given. The UK Quantum Technology Hub in Sensors and Metrology [1] has the aim of developing integrated, small and practical cold atom systems for a range of sensor and timing applications which includes rotation, magnetism, gravity and atomic clocks. The approach is similar to that pioneered by the chip scale atomic clock [2] where atoms held in microfabricated vacuum chambers have atomic transitions excited and probed by diodes lasers [3] and photodetectors. That system used coherent population trapping for the clock transitions whilst we are aiming to first produce lasers for cooling and trapping ions inside vacuum chambers before microwave pulses or controlled lasers are used to create superposition states, recombine them and measure the interference from the final state populations. For cooling 87Rb atoms, 780.24 nm lasers with linewidths below ~5 MHz are required whilst the lasers for controlling and measuring superposition states typically external cavity lasers have been used to achieve linewidths from 20 kHz [3] down to a few Hz [4]. Most single mode diode lasers aimed at laser cooling have used DBR gratings with regrowth [5] but this is challenging when using AlGaAs materials due to oxidation.Here we present single mode 780.24 nm DFB AlGaAs/GaAs lasers with output powers up to 50 mW and sidemode suppression ratios above 46 dB (Fig. 1(a)) using sidewall etched gratings (Fig. 1(b)) and no regrowth. The lasers demonstrate clear DFB performance allowing tuning through the required 780.24 nm without any mode hopping. Initial tests for short ridge devices indicate linewidths of ~10 MHz and initial lifetime tests have exceeded 200 hours. We will discuss methods being pursued to increasing the power and reducing the linewidth through longer ridges [5], coupled cavities and by integrating SOAs. Control of the population of electrons in hyperfine split states requires two laser outputs spaced by ~3.617 GHz. Fig 1(c) demonstrates the principle of two DFB lasers operated on the same waveguide where the present line spacing has been increased to 30 GHz to allow a clear measurement by our OSA. Careful control of the gratings and the current enable 3. 617 GHz to be achieved. We will present results comparing two coupled DFB lasers (Fig. 1(c)), direct modulation, external AOMs and integrated AOM approaches and discuss which are best suited for integrated cold atom systems