Simultaneous operation of a Raman fiber amplifier and laser pumped by a dual-wavelength Nd(3+)doped fiber laser

©2005 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.This paper presents an experimental study on the dynamics of Raman fiber lasers that use highly GeO/sub 2/-doped fibers as an active medium and a dual-wavelength (1060 and 1090 nm) Nd/sup 3+/-doped fiber laser as a pump source. The 1090-nm pump wavelength is located within the SiO/sub 2/ Raman gain spectrum relating to the 1060-nm pump wavelength, and competition is observed between Raman amplification of the 1090-nm emission with the 1060-nm emission used as the pump source and Raman lasing, which is independent of the 1090-nm amplification and which is also uses the 1060-nm emission as the pump source. Several pump configurations have been demonstrated to generate specific Stokes emissions generated through Raman lasing or amplification. Changing the gain-to-loss ratio by introducing intracavity loss of Raman emissions or increasing the Raman fiber length within each configuration can force either Raman amplification or lasing to dominate. The maximum slope efficiency as a function of the launched pump power was /spl sim/55% with a total output power of 1.6 W produced. A red shift of both the pump and the Stokes wavelengths is experimentally observed when the launched diode pump power is scaled up.Yahua Li, Stuart D. Jackson, Yucheng Zhao, and Simon Flemin