Control of switched reluctance machines

This thesis is concerned with the control of switched reluctance machines for both motoring and generating applications. There are different control objectives in each case. For motoring operation, there are two possible control objectives. If the SRM is being employed in a servo-type application, the desire is for a constant output torque. However, for low performance applications where some amount of torque ripple is acceptable, the aim is to achieve efficient and accurate speed regulation. When the SRM is employed for generating purposes, the goal is to maintain the dc bus voltage at the required value while achieving maximum efficiency. Preliminary investigative work on switched reluctance machine control in both motoring and generating modes is performed. This includes the implementation and testing through simulation of two control strategies described in the literature. In addition, an experimental system is built for the development and testing of new control strategies. The inherent nonlinearity of the switched reluctance machine results in ripple in the torque profile. This adversely affects motoring performance for servo-type applications. Hence, three neuro-fuzzy control strategies for torque ripple minimisation in switched reluctance motors are developed. For all three control strategies, the training of a neurofuzzy compensator and the incorporation of the trained compensator into the overall switched reluctance drive are described. The performance of the control strategies in reducing the torque ripple is examined with simulations and through experimental testing. While the torque ripple is troublesome for servo-type applications, there are some applications where a certain amount of torque ripple is acceptable. Therefore, four simple motor control strategies for torque ripple-tolerant applications are described and tested experimentally. Three of the control strategies are for low speed motoring operation while the fourth is aimed at high speed motoring operation. Finally, three closed-loop generator control strategies aimed at high speed operation in single pulse mode are developed. The three control strategies are examined by testing on the experimental system. A comparison of the performance of the control strategies in terms of efficiency and peak current produced by each is presented