Argon extraction from geological samples by CO2 scanning laser step-heating

Abstract: Lasers are fundamental tools for sampling in geochemical studies and have found wide application in mass spectrometric sample introduction systems. Here we describe an isotope extraction method for 40Ar/39Ar geochronology using a new scanning CO2 laser system. This method can partially un-mix radiogenic (40Ar*) from trapped argon components and provides an alternative to furnace step-heating methods. A key advantage of the laser scanning method developed at the Scottish Universities Environmental Research Centre (SUERC) is the ability to step-heat samples as large as 100 mg to fusion using low raster speeds, although care must be taken to avoid self-shielding of grains and proper laser targeting. The scanning laser extraction system has the potential for lower overall blanks and the ability to run blanks and calibrations between steps of a heating sequence. This provides better control on system performance and characterization during sample measurement and can result in improved data quality. Supplementary material: Ar/Ar data presented in Figures 6a–c and 7 (obsidian) is available a