Investigation of Applicability of Transporting Water Mist for Cooling Turbine Vanes," ASME paper GT2012-70110

This paper presents a numerical study to investigate the feasibility of transporting mist through the internal cooling channel in high-pressure turbine vanes for film cooling over the vane's surface. The idea of using mist film cooling to enhance conventional air cooling has been proven to be a feasible technique in the laboratory conditions and by computational simulations. However, there is a challenge to this technique to prove that the water mist can survive in the very hot environment inside the gas turbine casings and internal air passages and be delivered to the film injection holes. Both a zero-dimensional mist evaporation analytical model and 3-D computational fluid dynamic (CFD) scheme are employed for analysis. In the CFD simulation, the Lagrangian /Eulerian method is used along with the discrete phase model (DPM) to track the evaporation process of water droplets. The high-pressure water mist is injected into the stream of cooling air extracted from the compressor through the outer gas turbine casing near the vane before it reaches the vane internal cooling cavity. Using the mist equivalent of 10 % of the cooling air mass flow rate, the results show that, when the liquid droplets are atomized to 30 µm in diameter initially, the droplets can survive inside the internal cooling passages and be delivered to the film cooling injection hole location with droplets of 20 µm in diameter; and alternatively, an initially 20 µm droplet can be delivered at 12µm in diameter, which is sufficiently large for completing the required external film cooling task