Add to ORKGDeflection is an important serviceability limit state to be satisfied in the design of concrete structures. In recent times, high strength concrete and steel have been used widely in construction. This has resulted in the design of beams of smaller depths, which may undergo greater deflections. This has been investigated in references [1–12]. Basically, there are two approaches used in the design offices: viz. (1) control of deflection approach; and (2
AbstractIn the flexural design of reinforced concrete (RC) beams, the strength and deformability, wh...
In multi-storeyed buildings, if we select section of the beam according to traditional methods to en...
AbstractIn order to satisfy the serviceability limit states, a concrete structure must be serviceabl...
Indirect deflection control usually applies the limitation of the span-to-depth ratio. The procedur...
This paper reports the main results of a parametric analysis which was performed to define appropria...
Building codes and standards include methods and provisions for deflection control and determining ...
In the design of reinforced concrete structures several limit states are usually verified using simp...
Concrete flat slabs structures are economic and the most popular form of concrete used in multi-stor...
In the design of reinforced concrete (RC) beams, apart from providing adequate strength, it is also ...
Eurocode 2 (EN 1992-1-1:2004) instructions for deflection control are discussed in the paper. Severa...
In the design of reinforced concrete (RC) beams located in low-moderate seismicity regions, adequate...
"December 5, 1962.""Reprint from Journal of The American Concrete Institute Title 59-22, Proceedings...
The use of high-performance materials (HPMs) such as high-strength concrete (HSC) and high-strength ...
80 p.Concrete deep beams, referring to beams having span-to-depth ratio of about 5, are structural m...
High strength concrete (HSC) has revolutionised the construction industry in the 1980’s and in recen...
AbstractIn the flexural design of reinforced concrete (RC) beams, the strength and deformability, wh...
In multi-storeyed buildings, if we select section of the beam according to traditional methods to en...
AbstractIn order to satisfy the serviceability limit states, a concrete structure must be serviceabl...
Indirect deflection control usually applies the limitation of the span-to-depth ratio. The procedur...
This paper reports the main results of a parametric analysis which was performed to define appropria...
Building codes and standards include methods and provisions for deflection control and determining ...
In the design of reinforced concrete structures several limit states are usually verified using simp...
Concrete flat slabs structures are economic and the most popular form of concrete used in multi-stor...
In the design of reinforced concrete (RC) beams, apart from providing adequate strength, it is also ...
Eurocode 2 (EN 1992-1-1:2004) instructions for deflection control are discussed in the paper. Severa...
In the design of reinforced concrete (RC) beams located in low-moderate seismicity regions, adequate...
"December 5, 1962.""Reprint from Journal of The American Concrete Institute Title 59-22, Proceedings...
The use of high-performance materials (HPMs) such as high-strength concrete (HSC) and high-strength ...
80 p.Concrete deep beams, referring to beams having span-to-depth ratio of about 5, are structural m...
High strength concrete (HSC) has revolutionised the construction industry in the 1980’s and in recen...
AbstractIn the flexural design of reinforced concrete (RC) beams, the strength and deformability, wh...
In multi-storeyed buildings, if we select section of the beam according to traditional methods to en...
AbstractIn order to satisfy the serviceability limit states, a concrete structure must be serviceabl...