The analysis of a two-phase zone with condensation in a porous medium

The one-dimensional steady-state heat and mass transfer in a two-phase zone of a water-saturated porous medium is studied. The system consists of a sand-water-vapour mixture in a tube that is heated from above and cooled from below. Under certain conditions, a two-phase zone of both vapour and water exists in the middle of the tube. A model problem for the temperature and the liquid saturation pro les within this two-phase zone is formulated by allowing for an explicit temperature dependence for the saturation vapour pressure together with an explicit saturation dependence for the capillary pressure. A boundary layer analysis is performed on this model in the asymptotic limit of a large vapour pressure gradient. This asymptotic limit is similar to the large activation energy limit commonly used in combustion problems. In this limit, and in the outer region away from any boundary layers, it is shown that the temperature prole is slowly varying and that the corresponding saturation prole agrees very well with that obtained in the previous model of Udell [Journ. Heat Transfer, 105, (1983), p. 485] where strict isothermal conditions were assumed. The condensation and evaporation occurring within the boundary layers near the edges of the two-phase zone is examined. Finally, an iterative method is described that allows the temperature prole in the two-phase zone to be coupled to the temperature proles in the two single-phase zones consisting of either water or vapour. This allows for the computation of the locations of the edges of the two-phase zone within the tube. Numerical computations are performed with realistic values of the parameters