The tribological properties of monolayer KCl films on iron in ultrahigh vacuum: Modeling the extreme-pressure lubricating interface

The friction coefficients of thin KCl films deposited onto clean iron in ultrahigh vacuum are measured using a tungsten carbide tip. A rapid decrease is found in the friction coefficient from 2 for clean iron to 0:27 0:03 after the deposition of 40 A of KCl. Based on previous contact resistance measurements, this was proposed to be due to the completion of the first layer of KCl. The first-layer KCl coverage was measured by adsorbing deuterium onto an iron surface partially covered by KCl, where deuterium selectively adsorbs onto the iron. This revealed that the first monolayer is complete after the deposition of 40 A of KCl and that the first-layer KCl film coverage ð1Þ KCl is given by ð1Þ KCl 1 expð0:39 0:02tÞ, where t is the film thickness. XPS data suggest that heating a KCl film to550K causes it to wet the surface. This leads to decreases in the friction coefficients for thin KCl films in accord with the idea that friction is reduced by the first monolayer of KCl on iron. Temperature-programmed desorption data indicate that KCl in the first monolayer is 5 kJ/mol more stable than the multilayer consistent with the wetting behavior. Finally, the kinetic data are analyzed to suggest that the first-layer film is 2.6 A thick